|
|
#1
08-29-2009, 08:32 PM
|
|||
|
|||
No signal Quality
I just got my new dish 36" with legacy quad polar,QPH -031 lnb with H&H motor, Viewsat ultra 2000, which I have had for a while, programed and working. Went through all the steps to find true south, by going to galaxy 3C @ 95.0w which is my southern most bird from where I am to ck. signal strength w/ meter and have between 75 - 85 signal on any sat I try to program, but "0" signal quality. What am I missing? This is my first attempt @ true FTA,and iI am not very good at it . thanks
|
|
#2
08-30-2009, 01:12 AM
|
||||
|
||||
|
signal don't mean a whole lot you are looking for quality.make sure you are using a active transponder freq then move east and west up and down very slowly untill you get a quality reading.
__________________
Rainman's Equipment Undien 4600,DSR 922 Fortec Ultra, Satworks 3618 2 Fortec Mercury II Fortec Classic NA 8.5' Orbitron polar C Ku dish 8.5' Birdview HH C Ku dish 100cm Fortec dish 90cm Fortec dish 2 DG-240 HH motors Co Rotor II feed horn Norsat 8515 C band lnb Norsat 4506A Ku lnb BSC-621-2 Lnbf Invacom QPH-031 Lnbf Invacom SNH-031 Lnbf Fortec Fsku-v universal Lnbf V-Box
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
